all they needed to do was add some cribbage between the rails and the backplate then tip the forks back and it would have been fine. four of those lifts could do that lift no problem but god damn, you have to use your triangle of stability or else exactly this happens, and you have to be extra careful with a team pick when you start to drive or else you get trouble. They were on a incline on the embankment so they felt stable but as soon as they rolled off that they found bad times. idiot directing this thing had them clear of the car six inches below where he had them raise too. obviously this was poorly planned out too if they hadnt picked this kind of losd before they should have discussed the plan before and then got it done. Could have also loaded the backs of the forklifts down while lifting and tipoing to add a little extra stability then taken that off and driven back. if they had four Taylor lifts im sure they could have found a couple small forklifts to put on the back there tines pressing down on their counterweights. of course osha doesnt technically allow this in our country.
idiot directing this thing had them clear of the car six inches below where he had them raise too. obviously this was poorly planned out too if they hadnt picked this kind of losd before they should have discussed the plan before and then got it done. Could have also loaded the backs of the forklifts down while lifting and tipoing to add a little extra stability then taken that off and driven back. if they had four Taylor lifts im sure they could have found a couple small forklifts to put on the back there tines pressing down on their counterweights. of course osha doesnt technically allow this in our country.